FEATURES
-
Connects small or medium size
offices to the Internet/Intranet
-
IP/IPX routing and standard
bridging
-
Supports data services over
E1/T1, Fractional E1/T1, Frame Relay, ISDN, DDS and leased line
-
Optional sub-E1/T1 or analog
voice drop & insert ports for voice connectivity over E1/T1 services
-
Digital and analog voice
interfaces
-
One or two WAN ports - V.35,
V.24, X.21, V.36, RS-530
-
E1/T1 uplink over copper or
fiber
-
Supports Frame Relay, PPP and
MLPPP
-
COD (Connection On Demand) and
BOD (Bandwidth On Demand)
-
PSTN or ISDN dial backup
-
One or two Ethernet LAN
interfaces
-
Optional integrated 4-wire modem
for campus applications
-
Solid Firewall (session-based)
protection
-
NAT and Single IP address
translation
-
DHCP server
-
PAP/CHAP security
-
Quick setup and configuration
-
SNMP and Telnet support
-
FLASH memory for software and
parameter file downloading
E1 FEATURES
-
Integral E1 with or without LTU
-
Optional sub-E1 drop & insert
port for PABX connectivity
-
Fail-safe bypass for the sub-E1
link
-
Optional fiber optic uplink
T1 FEATURES
-
Integral T1 CSU/DSU
-
Optional sub-T1 drop & insert
port for PABX connectivity
-
Fail-safe bypass for the sub-T1
link
-
Optional fiber optic uplink
ANALOG VOICE FEATURES
-
Supports four analog channels
-
PCM encoded, A-Law or ?-Law
-
Supports three interface
options:
-
2-wire FXS
-
2 wire FXO
-
4-wire or 2-wire E&M
-
T1 or fractional T1 CSU/DSU,
operating at up to 1.544 Mbps
-
E1 or fractional E1, with or
without LTU, operating at rates up to 2.048 Mbps
-
E1 or T1 over fiber optic
links
-
Frame Relay with auto learn of
DLCI and maintenance protocol
-
ISDN BRI
-
DDS
-
Leased lines.
-
A variety of data interfaces are
available, such as V.35, V.24, V.36, X.21, and ISDN BRI.
-
IP Service Access
Authentication that is provided by PAP/CHAP
-
Solid Firewall that
protects an office LAN from undesired entry from the Internet
-
NAT that allows the
sharing of several legal IP addresses between the various LAN users
-
Single IP address
translation that allows a small or medium office LAN to connect to the
Internet, using a single dynamically or statically allocated IP address
-
DHCP server that allows
the sharing of IP address pools between DHCP clients on the LAN.
SPECIFICATIONS
E1 INTERFACE
? Framing
256N (no MF, CCS)
256N (no MF, CCS) with CRC-4
256S (TS16 MF, CAS)
256S (TS16 MF CAS) with CRC-4
? Bit Rate
2.048 Mbps
? Line Code
AMI
? Zero Suppression
HDB3
? Impedance
120 ohms, balanced
75 ohms, unbalanced
? Signal Level
Receive:
0 to -36 dB / with LTU
0 to -12 dB / without LTU
Transmit:
3V (10%), balanced
2.37V (10%), unbalanced
? Jitter Performance
As per ITU G.823
? Connectors
RJ-48c 8-pin, balanced
Two BNC coaxial, unbalanced
? Compliance
ITU G.703, G.704, G.706, G.732
? Diagnostics
User activated local and remote loopbacks
T1 INTERFACE
? Framing
D4, ESF
? Bit Rate
1.544 Mbps
? Line Code
AMI
? Zero Suppression
Transparent, B7ZS, B8ZS
? Impedance
100 ohms,balanced
? Signal Level
Receive:
0 to -36 dB with CSU
0 to -10 dB without CSU
Transmit:
0, -7.5, -15, -22.5dB with CSU
Soft adjustable at 0 to 655 ft, without CSU
? Jitter Performance
As per AT&T TR-62411
? Connector
RJ-48c 8-pin, balanced
? Compliance
AT&T TR 62411, ANSI T1.403
? Diagnostics
User activated local and remote loopbacks
Network activated loops and FDL loops (RLB, LLB)
ANALOG VOICE
? Number of Voice Channels
4
? Modulation Method
PCM (per ITU-T G.711 and AT&T
PUB-43801), ?-Law or A-Law
? Interfaces
E&M:
2-wire or 4-wire, supporting
different types of E&M signaling: RS-464 Types I, II, III and V, and BT
SSDC5, configured by software
FXS:
Loop start, WINK start (reverse polarity) for direct connection to a
2-wire telephone
FXO:
Loop start, WINK start (reverse polarity) connection to a 2-wire
telephone exchange subscriber line
Nominal level: 0 dBm
Nominal impedance: 600 ohm?`.Return loss: (ERL), better than 20 dB
Frequency response (Ref: 1020 Hz):
?0.5 dB, 300 to 3000 Hz
?1.1 dB, 250 to 3400 Hz
Signal to total distortion, G.712, G.713 method 2: 0 to -30 dBm0: better
than 33 dB +3 to -45 dBm0: better than 22 dB
Idle channel noise: better than -70 dBm0 (+20 dBrnc)
Transformer isolation: 1500 VRMS
? Diagnostics
Local digital loopback towards the analog side
Remote analog loopback towards the remote side, activated from local side
1 kHz tone injection towards analog side
Activity indicators
ISDN
? Interfaces:
ISDN BRI, "S" and "U"
? Compliance
ETS 300012, I.430, NTT, 5ESS, DMS-100, NI1
ROUTING
? Types
STATIC, RIP-I, RIP-2, RIP/SAP
LAN INTERFACE
? Number of Ports
1 or 2
? Standards
Conforms to Ethernet / IEEE 802.3
? Types
10Base2 with coax connector
10BaseT with RJ-45 connector
LINK INTERFACE
? Protocols
PPP and MLPPP
Frame Relay - RFC 1490 HDLC
? Data Port Interfaces
V.35 with 34-pin female
V.24/RS-232 or RS-530 with 25 pin D-type, female
X.21 with 15-pin D-type, female via adapter cable
V.36/RS-422 with 37-pin D-type, female via adapter cable
FIBER OPTIC INTERFACES
? Types
850 nm LED for use over multimode fiber at distances up to 5 km (3 miles)
1300 nm LED for use over single mode fiber at distances up to 47 km (29
miles)
1300 nm laser diode for use over single mode fiber at distances up to 62
km (38 miles)
1550 nm laser diode for use over single mode fiber for extended range up
to 100 km (62 miles).
? Connectors
ST, FC/PC, SC
? Compliance
ITU G.921, G.956
GENERAL
? Indicators
POWER (green)
ON when unit is powered
READY (green) ON when packets can be transferred
LAN DATA (yellow) ON when a packet is received or transmitted on LAN side
LAN ERROR (red) ON when LAN interface indicates an error
LINK DATA (yellow) ON when a packet is received or transmitted on LINK side
LINK ERROR (red) ON when LINK interface indicates an error
RED ALARM (red) ON when T1 interface detects red alarm
YEL ALARM (yellow) ON when T1 interface detects yellow alarm
LOCAL SYNC LOSS (red)ON when E1 interface detects local sync loss
REMOTE SYNC LOSS (red) ON when E1 interface detects remote sync loss
? Power
100-230 VAC, 47-63 Hz,13 VA max
24/48 VDC
? Physical
Height: 4.4 cm / 1.8 in (1U)
Length: 24.0 cm / 9.6 in
Width: 21.6 cm / 8.5 in
Weight: 1.16 kg / 2.55 lb
? Environment
Temperature: 0-50C / 32-122F
Humidity: up to 90%, non-condensing
ORDERING
WR2/530/U
WR2/530D/U
WR2/DC/T1/U
WR2/DC/T1/U/S
WR2/DC/T1/V24/U
WR2/DC/V24/U
WR2/DC/V24D/U
WR2/DC/V35/U
WR2/DDS/U
WR2/E1/2U
WR2/E1/U
WR2/E1/U/S
WR2/IBU/U/T1
WR2/IBU/V35/U
WR2/T1/2U
WR2/T1/2U/FXO
WR2/T1/2U/FXS
WR2/T1/2U/S
WR2/T1/ST13/U/E&M
WR2/T1/ST13/U/FXO
WR2/T1/ST13/U/FXS
WR2/T1/U
WR2/T1/U/E&M
WR2/T1/U/FXO
WR2/T1/U/FXS
WR2/T1/U/S
WR2/V24/2U
WR2/V24/U
WR2/V35/2U
WR2/V35/U
WR2/V35/V24/U
WR2/X21/
APPLICATION


|