The Patton Model 2014 RS-530 to V.35 converter lets a synchronous RS-530 device communicate bi-directionally with a synchronous V.35 device. The Model 2014 requires no AC power or batteries to operate and supports data rates to 2 Mbps. Operating full or half duplex, the Model 2014 passes all necessary clocking and control signals, and is transparent to protocol.

The Patton Model 2014 connects directly to the synchronous RS-530 interface using a male or female DB-25 connector. A male or female M/34 connector at the end of an integral 6 foot (1.8m) cable plugs into the V.35 device. Models with any combination of "DTE" and "DCE" wiring are available, thus eliminating the need for special crossover cables.

Interfaces: EIA RS-530/RS-422 to CCITT V.35
Data Rates: Up to 2.048 Mbps
Transmission Mode: Full or half duplex
Protocol: Transparent to protocol
Clocking: Set by connected devices
Connectors: DB-25 male or female on RS-530 side, M/34 male or female on V.35 side
Temperature Range: 32-122?F (0-50?C)
Altitude: 0-15,000 feet
Humidity: Up to 95% non-condensing
Power Supply: None required, uses ultra low power from EIA data and control signals
Dimensions: 2.66"L x 2.10"H x 0.73"W (6.8 x 5.3 x 1.9 cm
Weight: 14 oz. (400 grams) including cable