 |
|
|
|
|
|
|
||
|
|
|||
|
|
|||
| ||||||||||||
|
Quick Eagle DL3150 Access Multiplexer
The DL3150 Access Multiplexer ships with both T3 and E3 firmware loaded, which enables you to select your preferred network interface during the initial setup and make the life easier for those customers that want to deploy their equipment worldwide. In this case, it takes just a stroke of a key to change between the T3 and E3 firmware. Extensive diagnostic and management features such as Ethernet management port, SNMP agent, or serial console port enable local and remote fault analysis. Ideal for carrier backbone connectivity via satellite, the DL3150 Access Multiplexers offer smooth clock support on the HSSI (towards the LAN) as well as asymmetric clock support towards the WAN. The DL3150 Access Multiplexer’s small footprint (you can fit two units side-by-side in a 19” rack) ensures an economical way of deployment. Main Features:
|
The
DL3150 Access Multiplexer is a cost-effective alternative to Quick Eagle’s
DL3100 Series, which enables you to connect your data terminal equipment (DTE)
devices to a public or private T3 / E3 network at full or sub-rate speeds. The
unit comes with a single HSSI port and supports symmetric and asymmetric data
rates of up to 34.2 Mbps (in 358 Kbps increments for E3) or 44.2 Mbps (in 300
Kbps increments for T3). 
