EtherWan EX3101 Ethernet Extender

The EtherWan EX3101 is a point-to-point DSL solution that efficiently extends 10/100 Ethernet circuits to over 600 meters (1,960 feet) at 30 Mbps using existing straight pair copper wire. The EX3101 will allow Ethernet connectivity in existing facilities without pulling extra cable. This is the perfect solution to Ethernet on the factory floor where systems have been upgraded from slower serial communications to Ethernet networking. Installation is easy with a single switch setting, one end is set for local and the other remote. The EX3101 is used in pairs to extend Ethernet connectivity over existing voice grade copper wire.

High-Speed Full-Duplex 30 Mbps communications link over existing copper cable, Symetrical on the VDSL 8 Speeds with speed indicator LEDs on top of unit 30 Mbps @ up to 1970 ft., ratchets down to 1 Mbps @ about 6200 ft. Operates transparent to high layer protocols such as TCP/IP

Auto-MDIX and Auto-sensing 10Base-T or 100Base-TX and Full or Half-Duplex on the Ethernet port Plug and Play design for simple installation, single switch config. Eleven status LEDs for simple monitoring of the device and connection status

Extend LAN connectivity to a remote site or between buildings Connect Ethernet over the last mile over existing copper infrastructure Connect new controller technology on the factory floor using existing wiring Extend Ethernet connectivity from a backbone network to an isolated location via copper wire transmit video and traffic controller information over existing copper wire