Adtran Total Access OPTI-3 Controller Module
1184002L3 SOI4JN3DAA
 

Adtran Total Access OPTI-3 Controller Module 1184002L3 SOI4JN3DAA
 

• SONET OC-3LR-1 optical interface
  • Rate: 155.52 Mb/s
  • Span length: Long Reach, 40 km
  • Wavelength: 1310nm (nominal)
• Dual SC optical connections
• Framing, multiplexing and mapping compliant with SONET standards
• OC-3 facility and equipment loopback
• Detects and indicates standard optical and SONET related alarms and conditions
• SONET level performance monitoring
• SONET line protection switching
• 1+1 equipment and facility protection for optical network interface
• 1:1 equipment protection for optical network interface
• Maximum 60ms protection switching time (OC-3 to low speed interface)
• Board-mounted manual APS control switch
• Provide three Clear Channel DS3 Signals (via BNC connectors)
• Two external DS1 BITS clock interfaces
• Three sense points including AUX1, AUX2, and AUX3
• Fully hot swappable
• External BITS, line, or free-run timing modes
• SONET Minimum Clock (SMC) with +/- 20 ppm accuracy
• OAM&P via data communication over Section DCC channel
• Support SONET section DCC bridging
• Controller cards Cross Copy Communication Link
• OAM&P interface via craft interface (DB-9)
• TL1, Telnet, SNMP, and TFTP over Ethernet
• Supports Software downloads locally via craft interface (DB9) and TFTP over Ethernet. Remote TFTP and YModem downloads supported when configured for Back-to-Back IP mode.
• TL1 management support
• Supports TL1-based GUI network management interface
• Provides 3 DS3 interfaces.
• Software-controlled DS3 Transmit Level Control
• Automatic Receive Equalization
• Software-controlled Remote and Local DS3 Loopback capability
• Monitors incoming Receive Signal for LOS (Loss Of Signal)
• Monitors the Receive Analog and Digital LOS
• Monitors Transmit Output signal for drive failure
• LED status indicators:
  • Board Status (Power/Fail)
  • Optic Status (LOL, LOF, etc.)
  • DS3 #1 Status
  • DS3 #2 Status
  • DS3 #3 Status
  • ACO
• External ACO input (RMC only)
• Three audible alarm outputs including Critical, Major, and Minor (RMC only)
• Three visual alarm outputs including Critical, Major, and Minor (RMC only)
• –20 VDC to –60 VDC input voltage range
• +20 VDC to +60 VDC input voltage range
• Power consumption between 7 and 10 watts (typical) per OCM
• Operating temperature range of −40°C to +65°C (installed in RMC)
• Operating temperature range of −40°C to +50°C (installed in WMC)
• Storage temperature range −40°C to +85°C
• Relative humidity up to 95 percent, noncondensing
• NEBS Level 3, GR-1089-CORE, GR-63-CORE and UL60950 compliant
• Meets applicable optical and SONET standards (GR-253, T1.101, T1.105.xx)

Adtran OPTI-3 Data Sheet

Data Connect Enterprise offers fulfillment of ADTRAN products
DCE also carries Like New, Refurbished, and Used ADTRAN equipment for resale and purchase
 along with Enhanced Warranty Protection Coverage.

Adtran Enterprise Product Specialists

Adtran Products